COLOR STEEL MACHINE — PROFILE STACKING PROJECT INPUTS
Complete one copy for each proposed product/bundle combination.
This is an enquiry aid, NOT an operating programme, installation drawing,
structural design, acceptance standard or approval record.
Leave unknown fields open. Label requested, measured and estimated information.
Send authorised drawings by email; the website form does not accept attachments.

COMMON PROJECT INFORMATION
Company / contact:
Product: C/Z purlin / floor deck:
Drawing number / revision / units:
Material designation / thickness definition / coating:
Minimum and maximum length:
Individual item weight / measured or estimated:
Existing roll former and cut-off arrangement:
Discharge height / travel direction:
Existing run-out equipment / layout reference:
Observed arrival intervals and observation conditions:
Requested output and timing boundary (not a guarantee):
Full bundle/stack removal method / handover position:
Who supplies receiving / removal / controls interfaces:
Confirmed utility information / supplier confirmation still needed:
Surface requirements / sample or photo reference:
Open questions and responsible person:

C/Z PURLIN SECTION — complete separately for each C, U or Z variant
Catalogue reference only: MCZ-Z-400-10, C/U/Z profiles.
Maximum lifting weight per individual profile: 300 kg.
Do not select MCZ-Z-400-10 if any individual profile weighs more than 300 kg.
This is not a finished-bundle load rating or the machine self-weight.
At or below 300 kg, geometry, tooling and bundle arrangement still need review.
Source: supplier-confirmed single-piece lifting limit, 11 October 2026.
Heaviest individual C/U/Z profile weight (kg):
Associated drawing / revision / sample ID:
Weight reference: measured / drawing-based / estimated / unknown:
Selection status: above 300 kg (exclude model) / at or below 300 kg / unresolved:
Documented length: 3,000–13,000 mm; width: 100–400 mm;
material thickness: 1.5–5 mm. Source: supplied export C-profile stacker DOCX.
These ranges do not approve every geometry, tooling or bundle arrangement.
Requested model / proposed supplier configuration:
Actual section family (C / U / Z) and width drawing reference:
Web / flange / lip / bend and hole-feature drawing references:
Incoming end view / open-side orientation / travel-direction reference:
Requested layer end-view sketch and bundle side-view reference:
Pieces per layer / layer count / orientation sequence:
Separators / alignment reference / strapping or labelling requested:
Change list: shape / gauge / length / orientation / bundle pattern:
Supplier to identify recipe changes / manual adjustment / additional tooling:
Representative sample IDs and unrepresented variants:

FLOOR DECK SECTION — complete for each deck profile
Rib cross-section / full-sheet drawing references:
Overall width / effective cover width (label separately if applicable):
Edge details / embossments / exposed face / protective film if present:
Incoming face label and orientation sketch:
Finished-stack face label / per-sheet or per-layer sequence:
Sheets per stack / separators requested / alignment reference:
Reference samples and surface-condition requirements:

ATTACHMENTS AND CONFIRMATION
Drawing and sample list:
Proposed supplier configuration reference:
Included / excluded / unresolved scope:
Items requiring written supplier confirmation:
Notes:

Machine limits, safe clearances, control definitions and operating settings
must come from the project-specific approved documents, not this blank sheet.